Learn networking by doing

Each lesson is a self-contained lab. Read the explanation, then jump straight into the NetForge-AI canvas with the topology pre-loaded.

Looking for the full networking curriculum? Browse the course →

IPv4 Subnetting in 20 minutes

Beginner·20 min

From /24 to /30: how prefix length carves up an IP space, why /30 is perfect for point-to-point links, and the math you must memorize for the exam.

Start lesson

Switching basics: MAC learning & flooding

Beginner·15 min

Watch a switch build its MAC address table from scratch. Understand exactly when a frame floods vs forwards, and why hubs were retired.

Start lesson

VLANs: access ports vs trunks

Intermediate·25 min

Segment a single physical switch into independent broadcast domains. Configure access VLANs, set up an 802.1Q trunk, and prove isolation with ping.

Start lesson

Static routing & default gateways

Intermediate·30 min

Why the network address matters more than the host address. Build a 3-router topology and write the static routes that make every PC reachable.

Start lesson

ARP: how IPs become MACs

Beginner·12 min

Layer 3 plans the trip; Layer 2 actually delivers. Trace the ARP request/reply that resolves every first conversation between hosts.

Start lesson

OSPF explained: neighbors, areas and cost

Intermediate·20 min

How OSPF routers become neighbors, why area 0 is the backbone, how cost picks the path — and the five mismatches that stop an adjacency.

Start lesson

DHCP explained: DORA, pools and relay

Beginner·15 min

Discover, Offer, Request, Acknowledge. Build a DHCP pool, relay it across subnets with ip helper-address, and fix a client with no address.

Start lesson

NAT and PAT explained: inside, outside and overload

Intermediate·15 min

Static NAT, dynamic NAT and PAT side by side. Share one public address across an office with overload and read the translation table.

Start lesson

Spanning Tree explained: root bridge and blocked ports

Intermediate·15 min

Why a redundant cable can melt a switched network, how the root bridge is elected, and which port Spanning Tree blocks to stop the loop.

Start lesson

Why does ping fail? A layer-by-layer checklist

Beginner·12 min

A bottom-up checklist for a failing ping — link, address, gateway, VLAN, routes both ways, ACLs — with the command that checks each step.

Start lesson