Show & diagnostics

show interfaces switchport

Per-port L2 details: administrative mode, operational mode, access VLAN, native VLAN, allowed VLANs.

Works on: SwitchMode: enable

Sample output

Name: Fa0/1
Switchport: Enabled
Administrative Mode: access
Operational Mode: access
Access Mode VLAN: 10

Name: Fa0/2
Switchport: Enabled
Administrative Mode: access
Operational Mode: access
Access Mode VLAN: 10

Name: Fa0/3
Switchport: Enabled
Administrative Mode: access
Operational Mode: access
Access Mode VLAN: 20

Name: Fa0/4
Switchport: Enabled
Administrative Mode: access
Operational Mode: access
Access Mode VLAN: 20

Name: Fa0/5
Switchport: Enabled
Administrative Mode: access
Operational Mode: access
Access Mode VLAN: 99

Name: Fa0/6
Switchport: Enabled
Administrative Mode: access
Operational Mode: down
Access Mode VLAN: 1

Name: Fa0/7
Switchport: Enabled
Administrative Mode: access
Operational Mode: down

Truncated at 40 of 158 lines — run it in the lab for the full output.

Captured from the NetForge-AI simulator running a real topology.

Run this command live

Don't just read it — type show interfaces switchport in a real network simulator in your browser and watch it take effect. No install, no account needed to start.

Open the lab

Frequently asked

What does the "show interfaces switchport" command do?

Per-port L2 details: administrative mode, operational mode, access VLAN, native VLAN, allowed VLANs.

More Show & diagnostics commands

show running-config show startup-config show ip interface brief show interfaces [iface]show interfaces status show vlan brief show mac address-table show ip route show ip route <protocol>show ip ospf neighbor show ip ospf interface show ip eigrp neighbors

← Back to the full command reference